物理安全检测
文章正文
EN 74-1脚手架和支承架用扣件、中心螺栓和底座-第1部分
EN 74-1脚手架和支承架用扣件、中心螺栓和底座-第1部分:管用扣件-要求和试验规程—标准名称
EN 74-1 Couplers, spigot pins and baseplates for use in falsework and scaffolds - Part 1: Couplers for tubes - Requirements and test procedures
EN 74-1脚手架和支承架用扣件、中心螺栓和底座-第1部分:管用扣件-要求和试验规程

EN 74-1脚手架和支承架用扣件、中心螺栓和底座-第1部分:管用扣件-要求和试验规程—适用范围
Scope:
This European Standard specifies, for right angle couplers, swivel couplers, sleeve couplers and parallel couplers working by friction: materials; design requirements; strength classes with different structural parameters including values for resistance and stiffness; test procedures; assessment; and gives recommendations for ongoing production control. For testing, screw couplers are tightened to a torque of 50 Nm and wedge couplers are tightened with a 500 g hammer until the jarring blow.
本欧洲标准规定,直角耦合器,旋转耦合器,套筒耦合器和并联耦合器摩擦工作:材料;设计要求;具有不同结构参数的强度等级,包括阻力值和刚度值;测试程序;评估;并对持续生产控制提出建议。为了测试,螺杆耦合器被紧固到50纳米的扭矩和楔形耦合器被紧固与一个500克的锤子,直到震动打击。

EN 74-1脚手架和支承架用扣件、中心螺栓和底座-第1部分:管用扣件-要求和试验规程—测试标准和要求

直角扣件(需要指定等级ClassA /ClassB)
EN 74-1 Slipping force抗滑
EN 74-1 Failure force抗破坏
EN 74-1 Pull apart force抗拉分
EN 74-1 Indentation压痕测试
EN 74-1 Cruciform bending stiffness and Cruciform bending ultimate moment (Class B only)十字抗弯刚度及极限弯矩(仅适用B级)

EN 74-1 Rotational stiffness and moment (Class B only)扭转刚度及转矩(仅适用B级)

旋转扣件 (需要指定等级ClassA/ClassB)
EN 74-1 Slipping force抗滑
EN 74-1 Failure force抗破坏
EN 74-1 Indentation压痕测试

外接扣件(需要指定等级ClassA/ClassB)
EN 74-1 Slipping force抗滑
EN 74-1 Bending moment(ClassB only)弯矩(仅适用B级)
----------------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------------
Copyright EcoSafene   备案号:闽ICP备09009213号-1