ASTM C1166: Test method for flame propagation

Article
 

ASTM C1166: Test method for flame propagation
 
ASTM C1166 test method for flame propagation - Test Standard
 
ASTM C1166 Standard test method for flame propagation of dense and cellular elastomeric gaskets and accessories.
 
ASTM C1166 test method for flame propagation - Scope
 
1. This test method covers a laboratory procedure for determining flame propagation characteristics of a dense or cellular elastomeric gasket (such as expansion, lock-strip or compression gasket) or an accessory (such as a setting block, spacer or shim) when exposed to heat and flame, with no significance being attached to such matters as fuel contribution, rate of flame spread, smoke developed, or the nature and temperature of the products of combustion.
2. The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only. Scope
 
ASTM C1166 test method for flame propagation - Calculation
 
Calculate the average flame propagation (FP) for R1through R6 according to the following equation
FP= ([R1o-R1 f]+ [R2o-R2f] +[R3o-R3f]+ [R4o-R4f] +[R5o-R5f] +[R6o-R6f]) / 6
 
Where:
R1o=original R1
R1 f= final R1
R2o=original R2
R2 f= final R2
 
ASTM C1166 test method for flame propagation-Relative Standard
 
- ASTM C717 Terminology of Building Seals and Sealants
- ASTM C864 Specification for Dense Elastomeric Compression Seal Gaskets, Setting Blocks, and Spacers
- ASTM E662Standard Test Method for Specific Optical Density of Smoke Generated by Solid Materials
- ASTM E162Standard test method for surface flammability of materials using a radiant heat energy source
- ASTM E648Standard Test Method for Critical Radiant Flux of Floor-Covering
Systems Using a Radiant Heat Energy Source
 
 
----------------------------------------------------------------------------------------------------------------------
[ Add to Favorites ]  [ Print this page ]  [ Close the window ]  [ Back to top ]
Copyright EcoSafene  闽ICP备09009213号-1